350z/V35 Skyline Rear Camber Arms

350z/V35 Skyline Rear Camber ArmsThe GKTech Z33 350z V35 Skyline Rear camber arms give you the ability to adjust and tune your vehicle's rear camber. When you lower your car negative camber is introduced. This reduces the contact patch of your tyres and thus available traction. Our rear camber arms are a direct replacement of the OEM arm and will correct this issue. Feature high quality 5 8" Teflon lined pillow ball rod ends which eliminate the flex found in factory rubber bushing

These are perfect for use where a coolant swirl pot is used

non extended version and PCML12TE)

- Shifter sits just 85mm from the rear of the bolt holes on the back of the gearbox

To top it off we're exclusively using high-quality Teflon lined bearings (over $140 in bearings cost for the pair on their own) Our rear lower control arms allow for + or - 15mm's of track width and are the only LCA's that we know of that allow adjustment perpendicular to the centreline of the car which means that as you change the width your wheel doesn't push further back or forward into the wheel arch (unintentionally altering your suspension curves)

May not work with other subframe bushes

S13/180sx Roll center correction kit balljoint shankwhich includes the top nut

- High quality billet aluminium 6061-T6 construction

anti-lift is reduced from 80% to 20% assisting in braking by reducing wheel travel and preventing droop when hard braking

The V2 GKTECH roll center correction kit is now made from 1030 forged steel and provides 40mm of roll center correction

Manufactured from high quality ABS plastic

The Gktech stepped knurl gearknob is super comfortable to drive with and comes in at 140mm in height

The GKTECH S/R chassis rear Swaybar end links are a direct replacement of the OEM end link but with Polyurethane bushes rather than the OEM (typically worn) rubber bushes