ExpressLRS EP Receiver (Happymodel)

ExpressLRS EP Receiver (Happymodel)The Happymodel 2. 4GHz ELRS nano series receiver is an open source program based on ExpressLRS, we have 3 types rx module released. The PP RX is designed by @Jye Smith from ExpressLRS development team. Its main hardware architecture is STM32L432KBU6 MCU and SX1280 RF chip. It has a built in ceramic antenna, which is super light and small in size. On the basis of PP RX, we have developed the Nano 2. 4GHz rx of ESP8285 version named EP1 and EP2. The RF

A folding handle for easy transport a standard JR shaft for expansion with external modules and a battery shaft are located at the back of the radio

In addition to the classic charcoal and transparent case colors

fitting effortlessly into your FPV bag for easy access during flights

Accessory: Shock-absorbing Components for O4 Air Unit

Rated voltage: 25

1mm height

4G RX is available to support upgrading to ELRS V3

countersunk holes on extended power soldering pad enable each layer board can be powered

Cycle charge-discharge

Product NO

Both filters equipped with a rubber pad in the inner ring which can prevent them from falling off

0 Gyro BMI270 BMI270 FC Firmware BETAFPVF411 BETAFPVF411RX UART Port One UART Port Two UART Ports External RX Not Supported Supported