Offset caster rod bush inserts

Offset caster rod bush insertsThe GKTECH Billet Aluminum offset caster rod end inserts replace the inserts that go into the rose joint of your caster rod and give around 10mm more wheel clearance by moving the caster rod over. These are an easy DIY direct replacement that shouldn't take longer than 10 15 minutes to install. Machined from billet 7075 T6 aluminium and anodized for longevity.

Going to a one piece design also has allowed us to increase the caster angle by 2-3 degrees and this can be further increased by our front upper camber arms which have the adjustment to increase caster by up to 1 degree

- Corrects bump steer up to 25mm

Replaces factory Nissan part # 30610-91P57

- OEM S-chassis single piston calipers can be used in a single or dual configuration BUT the drum lever won't fit without modifications

which also have a common (YPB6T) bearing for serviceability

Nissan #30620-05U01

- Feature 5/8" Teflon lined spherical bearings which eliminates the flex found in factory rubber bushing offering a more direct and predictable feel

- DIY installation (not as easy as the washer install but still not hard at all)

0mm thick aluminium

using a GKTECH kit and a 5 mm lower tie rod position almost completely removes bump steer

The V2 GKTECH roll center correction kit is now made from 1030 forged steel and provides 1

This is a common modification for anyone looking to get more forward bite on their S13 and we’ve now made it easier than ever