R32/R33/R34 GTR roll center adjusters

R32/R33/R34 GTR roll center adjustersThe GKTECH billet aluminium GTR roll center adjusters are an easy DIY bolt in and provide a notable difference in the handling of your vehicle, particularly for lowered cars. When your car is lowered, like most GTRs are, the lower arm will now be pointing slightly upwards which will lower the roll center (which is the point at which the car rolls about) this gives the car leverage and makes it easier for the car to roll from side to side. We want to

NOTE: Can NOT be used in conjunction with Nismo engine mounts on an S13/180sx as the mounts raise your motor approximately 20mm's which will make our fan hit your radiator shroud (our fan is 15mm larger in diameter than the OEM SR20 fan) however S14/S15's with Nismo engine mounts are fine and our fan will fit

Replacement PCML12TE bearing (can also be replaced with PCML12T

increasing roll resistance and ultimately putting the roll center BACK to where it should be

Z33/350z Rear camber arms (SKU = 350Z-CMBR)

Ball joints for S13/180SX/A31 can be seen here: BJ274 Ball Joint

- Designed to be used with OEM knuckle

The GKTECH Z34 370z/V36 Skyline angle kit is a simple

NOTE: Will fit both LHD and RHD vehicles

NOTE: Will NOT suit cars with HICAS previously installed unless you use our lockout bar with clevis to suit (for this configuration use our S13 toe arms even on an S14/S15/R33/R34)

9 fittings

they are CAD designed

When installing the fan ensure that there is at least 10-20mm's clearance between the fan and anything around it