QTY 5 - 8mm Keyed Motor Output Shaft

QTY 5 - 8mm Keyed Motor Output ShaftUse the same gear pinions that you've always loved with the 8mm Keyed Motor Output Shaft. This output shaft will allow teams to utilize keyed motor pinions historically used on legacy FRC motors. Note: VEX Robotics has updated their Falcon 500 motor design. Any new motors received in 2023 with the updated design will not likely work with this shaft. Proceed accordingly. Material 316 Stainless Steel Added 3 8" deep 10 32 threaded hole in end of the

Square Size: 19mm

With a total of four channels and a built-in power conversion circuit

25" OD x 1

75 pounds - 1 bearing block + hardware and bearings weighs 3 ounces

LED Protocol: WS2812B / NeoPixel compatible

Compatible Mounting Hole Patterns: 4x 10-32 on a 1

Easily wire up your robot with these genuine WAGO 221-2401 inline splicing connectors with lever

Included in your purchase -

24mm x 15mm x 5mm Bearing 6802 Radial Bearing 3 21mm x 12mm x 5mm Bearing 6801 Radial Bearing 1 15mm x 10mm x 4mm Bearing 6700 Radial Bearing 4 14mm x 8mm x 4mm Bearing M148 Radial Bearing 1

Material: Steel - Rockwell C61 Hardness

- AndyMark 57 Sport planetary gearboxes

Inspired by teams making sector and turret gears as low backlash as possible